Table of Contents
Advertisement
DHCP-Acquired DNS Servers
#1 - #3
GPRS-Acquired DNS Servers
#1 - #3
TCP Keepalive Parameters
Start Probes
Number of Probes
Interval
Gateway
Default
DHCP-Acquired
GPRS-Acquired
Precedence
Enable IP
Forwarding
Fail-Over Settings
Fail-Over Gateway IP
Address
IP Address to Ping
SLB™ Branch Office Manager User Guide
Displays the IP address of the name servers if automatically assigned by DHCP.
Displays the IP address of the name servers if automatically assigned by General
Packet Radio Service (GPRS).
Number of seconds the SLB branch office manager waits after the last transmission
before sending the first probe to determine whether a TCP session is still alive. The
default is 600 seconds (10 minutes).
Number of probes the SLB unit sends before closing a session. The default is 5.
The number of seconds the SLB device waits between probes. The default is 60
seconds.
IP address of the router for this network.
If this has not been set manually, any gateway acquired by DHCP for Eth1 or Eth2
displays.
All network traffic that matches the Eth1 IP address and subnet mask is sent out
Eth1. All network traffic that matches the Eth2 IP address and subnet mask is sent
out Eth 2.
If you set a default gateway, any network traffic that does not match Eth1 or Eth2 is
sent to the default gateway for routing.
Gateway acquired by DHCP for Eth1 or Eth2. View only.
Displays the IP address of the router if it has been automatically assigned by
General Packet Radio Service (GPRS). View only.
Indicates whether the gateway acquired by DHCP or the default gateway takes
precedence. The default is DHCP Gateway. If the DHCP Gateway is selected and
both Eth1 and Eth2 are configured for DHCP, the SLB unit gives precedence to the
Eth1 gateway.
IP forwarding enables network traffic received on one interface (Eth1, Eth2, or an
external/USB modem attached to the SLB branch office manager with an active
PPP connection) to be transferred out another interface (any of the above). The
default behavior (if IP forwarding is disabled) is for network traffic to be received but
not routed to another destination.
Enabling IP forwarding is required if you enable Network Address Translation (NAT)
for any device port modem or USB/ISDN modem. IP forwarding allows a user
accessing the SLB unit over a modem to access the network connected to Eth1 or
Eth2.
An alternate IP address of the router for this network, to be used if an IP address
usually accessible through the default gateway fails to return one or more pings.
Note:
The fail-over gateway is not supported when DHCP is used.
IP address to ping to determine whether to use the fail-over gateway.
6: Basic Parameters
62
Advertisement
Table of Contents
