Power Commands; Host Lists - Lantronix 100-120 VAC SLB User Manual

2. Enter the following:
Switching Delay
Over Current Alarm
Current Level for all
Outlets
3. View or enter the following information for each outlet:
Outlet
Status
Name
Description (optional) User-configurable text describing the outlet.
Current
Power State
Wakeup Mode
Last State
Reboot
4. To save, click Apply.

Power Commands

Go to Power Commands (on page 316)
entries described above.

Host Lists

A host list is a prioritized list of SSH, Telnet, and TCP hosts available for establishing incoming
modem connections or for the connect direct command on the CLI. The SLB branch office
manager cycles through the list until it successfully connects to one.
To view, update or delete a host list:
1. Click the Devices tab and select the Host Lists option. The following page displays:
SLB™ Branch Office Manager User Guide
Number of milliseconds the SLB branch office manager between subsequent
switching. The range is 1000-2500 msec. The default is 2000 msec (2 sec).
If SNMP traps are enabled (see
sent if the total current for all outlets exceeds a threshold. Enter the number of
amps (measured in tenths of an amp) above which the SLB unit sends a trap. The
maximum is 180.
Note: If the alarm goes off, a warning message displays on the CLI.
Displays the total load carried by the outlets.
Displays the number of the outlet being configured.
Displays the current state of the outlet.
User-configurable name identifying the outlet.
Displays the load, in Amps, for the outlet.
Select whether the power should be on or off. Default is Off.
Select whether, after a reboot, the power state for the outlet should be on, off, or
returned to the state it was in before the reboot. Default is Off.
Select whether to return the outlet to the state it was in before the reboot.
To power cycle the outlet, select the checkbox. Default is unchecked.
Note: You can reboot the SLB device on the
Configurations page, but after the reboot, the power outlet has the same power
state as it did before the reboot.
to view CLI commands which correspond to the web page
Chapter 7: Services on page
Maintenance > Firmware &
8: Device Ports
84), a trap (alarm) is
132