Host List Commands; Scripts - Lantronix 100-120 VAC SLB User Manual

Authentication
Host
Protocol
Port
Escape Sequence
6. Click the right
7. Utilize the following options for managing the hosts in each host list:
To remove a host from the host list, select the host in the Hosts box and click the

left arrow.
To give the host a higher precedence, select the host in the Hosts box and click the

up arrow.
To give the host a lower precedence, select the host in the Hosts box and click the

down
8. Repeat steps above as necessary, to modify or add host lists.
9. Save your changes:
Click the Add Host List button if adding new host lists.

Click the Clear Host List button if editing existing host lists.

After the process completes, a link back to the

Host List Commands

Go to
Host List Commands (on page 302)
page entries described above.

Scripts

The SLB branch office manager supports three types of scripts:
Interface Scripts which use a subset of the Expect/Tcl scripting language to perform pattern

detection and action generation on Device Port output.
Batch Scripts which are a series of CLI commands.

Custom Scripts are Expect scripts that use most of the Expect scripting language, can be run

against the CLI or a Device Port, and can be scheduled to run at periodic intervals, with the
results from each run saved to a file in a repository. Up to 10 Custom Scripts can be created.
Each Custom Script run is an operation, and the results from each operation can be viewed.
Up to 50 script result files will be saved locally in the SLB storage. Once this maximum is
SLB™ Branch Office Manager User Guide
Select to require authentication when the SLB device connects to a host.
Name or IP address of the host.
Protocol for connecting to the host (TCP, SSH, or Telnet).
Port on the host to connect to.
The escape character used to get the attention of the SSH or Telnet client. It is
optional, and if not specified, Telnet and SSH use their default escape character.
For Telnet, the escape character is either a single character or a two-character
sequence consisting of '^' followed by one character. If the second character is '?', the
DEL character is selected. Otherwise, the second character is converted to a control
character and used as the escape character.
For SSH, the escape character is a single character.
arrow. The host displays in the Hosts box.
arrow.
Device Ports > Settings
to view CLI commands which correspond to the web
8: Device Ports
page displays.
134