Table of Contents
Advertisement
Initialization Script
Modem Timeout
Caller ID Logging
Modem Command
Dial-back Number
Dial-back Delay
Dial-back Retries
Modem Settings: Text Mode
Timeout Logins
Dial-in Host List
Modem Settings: PPP Mode
Negotiate IP Address
SLB™ Branch Office Manager User Guide
Commands sent to configure the modem may have up to 100 characters. Consult
your modem's documentation for recommended initialization options. If you do
not specify an initialization script, the SLB branch office manager uses a default
initialization string of
AT S7=45
SO=0
L1
Note:
We recommend that the modem initialization script always be preceded
with
AT
and include
E1 V1 x4 Q0
the modem. For information on AT commands, refer to the modem user guide, or
do a web search for
at command set
Timeout for all modem connections. Select Yes (default) for the SLB branch office
manager to terminate the connection if no traffic is received during the configured
idle time. Enter a value of from 1 to 9999 seconds. The default is 30 seconds.
Select to enable the SLB branch office manager to log caller IDs on incoming
calls. Disabled by default.
Note:
For the Caller ID
AT
Modem
command used to initiate caller ID logging by the modem.
AT
Note:
For the
command, refer to the modem user guide.
AT
Users with dial-back access can dial into the SLB unit and enter their login and
password. Once the SLB authenticates them, the modem hangs up and dials
them back.
Select the phone number the modem dials back on -a fixed number or a number
associated with their login. If you select Fixed Number, enter the number (in the
format 2123456789).
The dial-back number is also used for CBCP client as the number for a user-
defined number. See
Device Ports - Settings (on page 113)
For dial-back and CBCP Server, the number of seconds between the dial-in and
dial-out portions of the dialing sequence.
For dial-back and CBCP Server, the number of times the SLB device will retry the
dial-out portion of the dialing sequence if the first attempt to dial-out fails.
If you selected Text mode, you can enable logins to time out after the connection is
inactive for a specified number of minutes. The default is No. This setting is only
applicable for text mode connections. PPP mode connections stay connected until
either side drops the connection. Disabled by default.
From the drop-down list, select the desired host list. The host list is a prioritized list
of SSH, Telnet, and TCP hosts that are available for establishing outgoing modem
connections or for connect direct at the CLI. The hosts in the list are cycled
through until the SLB branch office manager successfully connects to one.
To establish and configure host lists, click the Host Lists link.
If the SLB unit and/or the serial device have dynamic IP addresses (e.g., IP
addresses assigned by a DHCP server), select Yes. Yes is the default.
If the SLB device or the modem have fixed IP addresses, select No, and enter
the Local IP (IP address of the port) and Remote IP (IP address of the
modem).
V1
X4
&D2
&c1
so that the SLB unit may properly control
.
command, refer to the modem user guide.
8: Device Ports
.
E1
Q0
for more information.
118
Advertisement
Table of Contents
