Commands; Device Port - Sensorsoft Device; Figure 8-7 Devices > Device Ports > Sensorsoft - Lantronix 100-120 VAC SLB User Manual

Infeed Status
System Info

Commands

Restart SLP
Control Outlet
2. Click the Apply button.

Device Port - Sensorsoft Device

Devices made by Sensorsoft are used to monitor environmental conditions.
1. In the Connected to field above the IP Settings section of the
select Sensorsoft.
2. Click the Device Commands link. The following page displays:
3. Select a port and enter or view the following information:
Dev Port
Device Port Name
Temp
Low Temp
High Temp
Use °F
Humidity (%)
Low Humidity
SLB™ Branch Office Manager User Guide
Click the link to view the status of the data the SLP unit is receiving.
Click the link to see system information pertaining to the SLP power manager.
To restart the SLP power manager, select the checkbox.
For Tower A or Tower B, select All Outlets or Single Outlet and the number
of the outlet to be controlled (1-8 for the SLP8 or 1-16 for the SLP16 devices)
and select the command for the outlet (No Action, Power On, Power Off, Cycle
Power). No Action is the default.
Figure 8-7 Devices > Device Ports > Sensorsoft
Displays the number of the SLB port.
Displays the name of the SLB port.
Current temperature (degrees Celsius) on the device the sensor is monitoring.
Enter the temperature (degrees Celsius) permitted on the monitored device below
which the SLB branch office manager sends a trap.
Enter the temperature (degrees Celsius) permitted on the monitored device above
which the SLB unit sends a trap.
Display and set the temperature for this device in degrees Fahrenheit, instead of
Celsius, which is the default.
Current relative humidity on the device the sensor is monitoring.
Enter the relative humidity permitted on the device the sensor is monitoring below
which the sensor sends a trap to the SLB device.
8: Device Ports
Device Port Settings page,
122