Table of Contents
Advertisement
Remote
Authentication
SSH Keys
User Menus
Web Access
Diagnostics &
Reports
Reboot & Shutdown
Firmware &
Configuration
Device Port
Operations
Device Port
Configuration
USB
Power Outlets
5. Click the Apply button.
Note:
You must reboot the unit before your changes will take effect.
NIS Commands
Go to
NIS Commands (on page 275)
entries described above.
LDAP
The system administrator can configure the SLB branch office manager to use LDAP to
authenticate users attempting to log in using the Web, Telnet, SSH, or the console port.
LDAP allows SLB users to authenticate using a wide variety of LDAP servers, such as OpenLDAP
and Microsoft Active Directory. The LDAP implementation supports LDAP servers that do not
allow anonymous queries.
Users who are authenticated through LDAP are granted device port access through the port
permissions on this page.
All LDAP users are members of a group that has predefined user rights associated with it. You can
add additional user rights that are not defined by the group.
SLB™ Branch Office Manager User Guide
Right to assign a remote user to a user group and assign a set of rights to the user.
Right to set SSH keys for authenticating users.
Right to create a custom user menu for the CLI for NIS users.
Right to access Web-Manager.
Right to obtain diagnostic information and reports about the unit.
Right to use the CLI or shut down the SLB branch office manager and then reboot
it.
Right to upgrade the firmware on the unit and save or restore a configuration (all
settings). Selecting this option automatically selects Reboot & Shutdown.
Right to control device port settings.
Right to enter device port settings.
Right to enter modem settings for USB devices.
Right to configure power outlets.
to view CLI commands which correspond to the web page
11: User Authentication
197
Advertisement
Table of Contents
