Table of Contents
Advertisement
13: Application Examples
Each SLB branch office manager has multiple serial ports and two network ports. Each serial port
can be connected to the console port of an IT device. Using a network port (in-band) or a modem
(out-of-band) for dial-up connection, an administrator can remotely access any of the connected IT
devices using Telnet or SSH.
This chapter includes three typical scenarios for using the SLB unit. The scenarios assume that
the SLB device is connected to the network and has already been assigned an IP address. In the
examples, we use the command line interface. You can do the same things using the web page
interface except for directly interacting with the SLB unit (direct command).
Telnet/SSH to a Remote Device
The following figure shows a Sun server connected to port 2 of the SLB.
Remote User
In this example, the sysadmin would:
SLB™ Branch Office Manager User Guide
Figure 13-1 SLB - Branch Office Manager Configuration
Figure 13-2 Remote User Connected to a SUN Server via the
Internet
SLB
Sun Server
SLB Branch Office Manager
248
Advertisement
Table of Contents
