Table of Contents
Advertisement
Send Packet
Loopback
SLB Internals
3. Click the Run Diagnostics button. The
4. To email this report, follow the instructions in
Diagnostic Commands
Go to
Diagnostic Commands (on page 295)
page entries described above.
Status/Reports
SLB™ Branch Office Manager User Guide
This option sends an Ethernet packet out one of the Ethernet ports, mainly as a network
connectivity test. For UDP, the number of times the string is sent is equal to the number
of packets sent. For TCP, the number of times the string is sent may (or may not) be
equal to the number of packets sent, because TCP controls how data is packetized and
sent out. Enter the following:
Protocol: Select the type of packet to send (TCP or UDP).
Hostname: Specify a host name or IPaddress of the host to send the packet to.
Port: Specify a TCP or UDP port number of the host to send the packet to.
String: Enter a set of up to 64 characters. The string is encapsulated in the packet (so
you could use a network sniffer to track the packet and, by looking at its contents,
verify that it was sent).
Count: The count is the number of times the string is sent.
Specify loopback information:
Device Port
Select either an Internal or External test
Select to display information on the internal memory, storage and processes of the SLB.
Figure 12-8 Diagnostics Report
Diagnostics Report
page displays.
Emailing Logs and Reports (on page
to view CLI commands which correspond to the web
12: Maintenance
241).
238
Advertisement
Table of Contents
