Maintenance After The Printing; Cleaning The Ink Fountain And Ink Fountain Roller - Ryobi 3302H Operation Manual

Chapter 1 RYOBI PCS-F
1-5 Maintenance after the Printing
lt.
Cleaning the Ink Fountain and Ink Fountain Roller
I
«NOTICE»
Be sure to return the ink fountain key opening volume to "0" before cleaning the ink section.
( • Optional Accessories- 13)
Optional Accessories Edition - 22
£WARNING
Stop the press before cleaning. Failure to follow this instruction
may result in a serious injury.
Remove the ink in the ink fountain.
Loosen the ink fountain fixing knobs and pull the ink fountain downwards.
Clean the side edges of the ink fountain roller, both sides of the ink
fountain, and edge of the ink fountain key well.
«NOTICE»
1. Do not use any powerful corrosive acid or chlorine type cleaning
solution on the metal. The metal may corrode when the acid or chlo-
rine reacts with the water.
Example of powerful corrosive chemicals:
Plate cleaner (powerful acid)
Blanket cleaner (chlorine type}
2. If the press will not be operated for 3 days or more, apply the rust
preventive oil on the ink fountain roller after cleaning it.
Also if the printing room environment is one with a high temperature
and damp, the metal will easily corrode and rust. Therefore in this
environment when not using the press the following day, apply the
rust preventive oil on the ink fountain roller after cleaning it.
Remove the plate
(1)
and then clean each ink fountain key. Clean well so
that the ink does not remain on the edge of the ink fountain key. Be
careful so as not to allow the ink to enter the inside (2). If there is any ink
on it, it should be removed completely.
When changing the color, remove the plate (1) and clean the inside (2)
following the same procedures above.