Ryobi 3302H Operation Manual page 241

~~
(1)
~
Chapter 1 RYOBI PCS-F
After cleaning, apply spray type oil in each clearance ( 1) between the ink
fountain keys.
(Note) After cleaning it, the plate should be set onto the ink fountain
correctly. Then check that the pins (2) are properly in the slots of
the plate.
«NOTICE»
1. You should use spray type oil that meets following requirements.
• A spray type oil which has a low viscosity.
[When the temperature is 40'C (1 04 'F), the viscosity of the oil is
lower than 10 est.]
• A spray type oil which does not damage the resin and rubber.
(Do not use an ester type lubricating oil.)
• A spray type oil which has the heat-resistant and high rust pre-
ventive effect.
• A spray type oil which does not affect the printing, if the oil and
ink mix. (Do not use a silicon type lubricating oil.)
2. Do not use spray type grease.
On this system, the following error messages will be indicated on the message display when trouble occurs. Before
calling for after sales service, please check the following.
Error message Cause Countermeasure
There is trouble with the inside data
INTERNALDATAISBROKEN
caused by a dead battery. (This
When pushing the ESC key, the
PRESS ESC KEY
message is indicated when turning memory will be reformatted.
the power ON.)
MISTAKE IN UNIT COLOR SETTING
When setting the conversion curve,
the same color is set on the multiple Set a different color on each unit.
PRESS ESC KEY
units.
MISTAKE IN CONVERSION CURVE
A number over 30 for the Set a conversion curve number
SETTING
conversion curve has been set. below 30.
PRESS ESC KEY
WRONG COLOR SETTING.
The color setting information
Change the color setting of this
which is read from the floppy disk
PRESS ESC KEY
has color information which cannot
system or read the same data as the
INPUT DATA[*** *** *** ***]
be read by this system.
color setting of this system.
PROBLEM OF DATA
The data not for this press is read.
Read out the data of this press
PRESS ESC KEY
again.
DISK IS NOT INSERTED
The READ, WRITE, FORMAT, or
Insert the floppy disk and do the
PRESS ESC KEY
DEL button is pushed without
operation again.
* 1
inserting the floppy disk.
DISK IS PROTECTED FROM WRITING The floppy disk write protect notch
Close the write protect notch.
*
1
PRESS ESC KEY is open.
DISK IS NOT FORMATTED
The floppy disk is not formatted.
Do the formatting of either a 2HD
PRESS ESC KEY or 2DD floppy disk.*
1
(Note) *1 :When the same message is shown over and over again, this may indicate trouble with the hardware. Please
contact your service technician.
Optional Accessories Edition - 23