Ryobi 3302H Operation Manual page 154

~
\
Chapter 3 Printing Practice
2) Setting the feeder board
Set the pull-out rollers (1) on both sides of the double sheet detector
(between the suction feet).
Use the 2 central suction feet.
Stop the vacuum of the suction feet not going to be used.
Set the guide rollers according to the paper size.
A
CAUTION
Stop the press before setting. Failure to follow this instruction may result in an injury.
'ion- 68
Loosen the board tape tension shaft and use the 2 inside board tapes.
Remove the push side guide fixing screws at the operation side and non
operation side and move the 2 outer board tapes to the outside of the push
side guide.
The 2 board tapes to be used should be positioned on both edges of the
minimum size paper.
(Note) Please be careful not to set the board tape over the paper feed
sensor.
Set the skid rollers on the board tapes. 12 skid rollers are used.
Set the skid rollers
(1)
with the long arm on the pull-out roller side.
Set the skid rollers (2) with the spring on the paper feed drum side. (There
are 2 types of the skid rollers for the operation side and non operation
side.)
Set the remaining skid rollers as shown in the illustration on the left.
(Note) 1. Any of the skid rollers should always be in contact with the
paper until the paper arrives at the stop finger.
2. 6 skid rollers are included with the press.
Set the push side guide and flat spring.
Change the mounting position of the flat spring.