Ryobi 3302H Operation Manual page 120

Chapter 1 Operation Procedures
( )
(3)
Operation Edition - 34
Run the press and push the paper size change button
to feed the paper to the stop finger.
(Reference) After the paper arrives at the stop
finger, the press stops auto-matically.
Loosen the fixing screw (2) and position the flat
springs (1) so that they are about 1 mm (0.039") from
the edge of the paper and fix it.
(Reference) On the flat spring plate (3), there is a
scale with 1 mm (0.039") interval
markings. Use this to set the standard
position of the flat spring.
Scale---~-
[ I
mm (0.039") ]
mterval
(3)
Push the forward crawl button and stop the jogger
guide (1) at its fully pushed position.
If the jogger guide does not contact the paper edge
in parallel, loosen the lock nut (2) and adjust the
jogger guide by using the adjustment screw (3).
Loosen the fixing screw (1) and adjust the jogger
guide (3) position so that the flat spring (2) is bent
about 1 mm (0.039").
Adjust the flat spring bending volume by using the
micro adjustment knob ( 4).
«NOTICE»
If the fixing screw is tightened by using the wrench
or other tool, the bracket may be damaged. Only
tighten the fixing screw by hand.