Chapter 1 Operation Procedures
5) Pre-pile system
A
CAUTION
Stop the press before setting. Failure to follow this instruction may result in an
injury.
Exchanging the paper pile board - - - - - - - - - - - - - - - - - - .
1. When the paper pile on
the frrst paper feed table
(1) becomes low, set the
second paper feed table
(2) on the second step
and pile the paper.
4. Set the release lever (1)
at the ~position and
turn the crank handle to
elevate the second paper
pile board.
2. After the frrst paper pile
is all printed, push the
paper feed button OFF.
5. Set the release lever at
the~ position.
3.
Lift the lever and re-
move the first paper
feed table.
6. Push the paper feed
button ON and start
printing again.
Printing Finished
Operation Edition - 58