Ryobi 3302H Operation Manual page 130

Chapter 1 Operation Procedures
Operation Edition - 44
2) Set the cycle set
button.
[Cycle type]
0 1
2
3 4
jPRINTI
-M
~
a:::J
eM
• •
5
6
7 8
9
cft<t
t~k
&
CY-0 ... Printing cycle
There are the following cycles for the printing
process.
When printing, the cycle set button should be set on "0".
CY-1. .. Wet cycle for the metal plate printing mode
This is the process that supplies dampening solution to the plate surface by contacting the water
form roller with the plate surface automatically before printing only when pushing the printing
start button with the set speed drive button lamp OFF to print in the metal plate printing mode.
If this process is not properly done, scumming will occur when starting printing or too much
dampening solution will be supplied.
CY-2 ... Inking cycle
This is the process that supplies ink to the plate surface by contacting the ink form rollers with
the plate surface automatically before printing only when pushing the printing start button to
print.
CY-3 ... Blanket cleaning cycle ( • Optional Accessories Edition - 28)
CY-4 •.. Wet cycle for the polyester plate or paper master printing mode
This is the process that supplies dampening solution to the plate surface by contacting the water
form roller with the plate surface automatically before printing only when pushing the printing
start button with the set speed drive button lamp ON to print in the polyester plate or paper
master printing mode.
If this process is not properly done, scumming will occur when starting printing or too much
dampening solution will be supplied.
CY-5 ...
!Rtij$~lwltn:;,S'emiautt)matiQ' 1 (aJat$:~:~HangerH
Wet cycle for mounting the paper
master
This is the process that supplies dampening solution to the plate cylinder surface by contacting
the water form roller on the plate cylinder surface before mounting the paper master only when
pushing the paper master mounting and removing program switch on the delivery section auxiliary
switch panel.
If this process is not properly done, the paper master is not fitted on the plate cylinder properly.
CY-8 .•• Cycle for the service technician
CY-9 •.• Cycle for the maintenance and inspection
(Note) 1. CY-6 and 7 have no function.
2. CY-8 and 9 are not necessary to set before printing.
3. CY-3 can be used on the press with the blanket cleaning device.
4. If the CY-5 is set to "0", this wet cycle is not done.