Ryobi 3302H Operation Manual page 177

Chapter 2 Periodic Inspection
(Note) The nip width should be measured both on the operation
and non operation sides after transferring it onto a sheet of
paper. Adjust so that both sides nip widths are the same and
equal the standard value.
(Note) When adjusting the pressure between the ink form roller and ink oscillating roller, the pressure with the
plate will change. (However even when adjusting the pressure with the plate, the pressure with the ink
oscillating roller will not change.) Therefore adjust the pressure with the ink oscillating roller first, and
after that, adjust the pressure with the plate.
a. The pressure between the ink form roller and ink oscillating roller (A, B, C)
Checking procedures - - - - - - - - - - - - - - - - - - - - - - - - - - - - - .
Shift the metering roller release lever in the direction of the arrow
( ~ position) to release the metering roller from the water
oscillating roller.
Apply ink on the roller thinly and run the press.
Set the water form roller release lever (1) at the
It]
position.
Maintenance Edition - 11