Test Feeding - Ryobi 3302H Operation Manual

Chapter 1 Operation Procedures
10. Test Feeding
• Test feeding
procedures
Drive button ON
'
Pump button ON
c.::::::l
~
(J
'
Paper feed button
ON
c.::::::l
'
Paper feed button
OFF
c.::::::l
'
Pump button OFF
c.::::::l
c0
'
Crawl ON/OFF
button ON
~
Operation Edition - 40
Feeding the sheets of paper, check and adjust each section.
1) Correct the slewed paper fed from the paper feed section.
When the paper fed is slewed on the feeder board,
adjust the pull-out roller pressure by using the
adjustment knob.
2) Control the delivery air blower volume.
(1)
Control the delivery air blower volume by using the
delivery air blower control knob (1).
When the paper drops strongly [1] or weakly [2], control the delivery air blower volume to drop
the whole sheet equally [3] by using the delivery air blower control knob.
~.:,.:,.:.~
[2]
[ 31
A
WARNING
Push the emergency stop button to stop
the press before adjusting. Failure to follow
this instruction may result in a serious injury.
The delivery air blower nozzle can be opened or
closed by turning the sleeve.
When printing on smaller size paper, close the
unnecessary delivery air blower nozzle. Adjust the
opening and closing of the nozzle depending on the
delivery condition of the printed paper.