Ryobi 3302H Operation Manual page 263

I
Optional Accessories Edition -
221
Chapter 1 RYOBI PCS-F
1-5 Maintenance after the Printing
1. Cleaning the Ink Fountain and Ink Fountain Roller
I
«NOTICE»
Be sure to return the ink fountain key opening volume to "0" before cleaning the ink section.
( .. Optional Accessories- 13)
A
WARNING
Stop the press before cleaning. Failure to follow this instruction
may result in a serious injury.
Remove the ink in the ink fountain and on the ink fountain roller.
Loosen the ink fountain fixing knobs and pull the ink fountain downwards.
Clean the side edges of the ink fountain roller, both sides of the ink
fountain, and edge of the ink fountain key well.
«NOTICE»
1. Do not use any powerful corrosive acid or chlorine type cleaning
solution on the metal. The metal may corrode when the acid or chlo-
rine reacts with water.
Example of powerful corrosive chemicals:
Plate cleaner (powerful acid)
Blanket cleaner (chlorine type)
2. If the press will not be operated for 3 or more days, apply rust
preventive oil on the ink fountain roller after cleaning it.
Also if the printing room environment is high temperature and/or
damp, the metal will easily corrode and rust. Therefore, apply rust
preventive oil on the ink fountain roller after cleaning it.
After cleaning, apply a little spray type oil on the edge of the ink fountain
key (1). After lubricating, wipe off any excess oil.
(Note) 1. You should use spray type oil that meets following
requirements.
• A spray type oil which has a low viscosity.
[When the temperature is 40°C (1 04 OF), the viscosity of the
oil is lower than 10 est.]
• A spray type oil which does not damage resin and rubber.
(Do not use an ester type lubricating oil.)
• A spray type oil which has the heat-resistance and offers
high rust protection.
• A spray type oil which does not affect the printing, if the oil
and ink mix. (Do not use a silicon type lubricating oil.)
2. Do not use spray type grease.
The "Error message display" does not change.
4