Ryobi 3302H Operation Manual page 180

Chapter 2 Periodic Inspection
<Adjustment procedures>
Push the crawl button and then check the nip width that appears on
the plate surface.
Loosen the lock nuts (1), (2), and (3) and tum the pressure adjustment
nuts (D), (E), and (F) to adjust the pressures.
The adjustment nuts are located at the 3 places each on the operation and
non operation sides. When turning them in the direction of the arrow on
the nuts, the pressure will be increased.
• Ink ftrst form roller and plate ......... (D)
• Ink second form roller and plate .... (E)
• Ink third form roller and plate ........ (F)
2) Checking and adjustment of the water roller pressure
A
WARNING
1. Never touch the rotating parts when doing the crawl operation.
2. Close the cover opened after finishing the inspection.
Failure to follow these instructions may result in a serious injury.
- Checking the roller pressure - - - - - - - - - - - - - - - - - - - - - - - - - - - - ,
CYCLE
SET
Maintenance Edition - 14
Push the cycle set button on the delivery section auxiliary switch
panel and set it to the cycle "9".
(Note) When setting it on the cycle "9", the press can be stopped
with the ink form rollers and water form roller in contact
with the plate surface. When checking and adjusting the
form roller pressure, the cycle should be set on "9". After
completing the adjustment, the cycle should be returned to
"0".