Ryobi 3302H Operation Manual page 121

Chapter 1 Operation Procedures
(Reference) There are 2 types of flat spring, one for
thin paper and the other for thick paper.
The thin flat spring is used for paper
with a thickness of less than 0.1 mm
(0.004").
(Reference) Switching over the push side guide from the operation side to the non operation
side can be done.
Switching over procedures-------------------.
1. Loosen the fixing screw
and remove the non
operation side flat
spring and mount it on
the operation side.
4. Loosen the screw (1) in
the condition where the
non operation side push
side guide is pushed
toward the frame side.
Move the push side
guide cam (2) by using
a screwdriver.
6. Mount the fixing screw
on the operation side
push side guide.
Remove the push side
guide fixing screw on
the operation side.
Push side
guide cam
(2)
At this time, connect the
non operation side stopper
(1) on the push side guide
cam to the pin (2) exactly.
Finally fix the fixing screw
(3).
«NOTICE»
3. Mount the screw (1) on
the non operation side
push side guide and fix
it and then loosen the
screw (2).
5. Remove the fixing
screw.
If the fixing screw is tightened by using the wrench or
other tool, the bracket may be damaged. Only tighten
the fixing screw by hand.
Operation Edition - 35