Ryobi 3302H Operation Manual page 161

Chapter 3 Printing Practice
(1) Close the leading edge clamp by turning the leading edge clamp open/
I~
a(1)
(2)
close bolt ( 1) in the direction ofthe arrow. At this time, tum the bolt
(1)
so that the center of the cam lever (2) is aligned with the upper line (3) on
the side plate of the plate cylinder.
(Reference) There are 2 lines on the side plate of the plate cylinder.
The upper line is a sign of the ON position of the leading
edge clamp, and the lower line is the ON position of the tail
edge clamp.
When doing the diagonal image adjustment manually, the
lower line is used to align with the cam lever so that the
tension of the tail edge clamp will be loosened.
Push the forward crawl button to mount the plate on the plate cylinder.
Stop the press at the position where the plate tail edge can be inserted
into the tail edge clamp. Fit the plate on the plate cylinder by pushing
down with your left hand, and insert the plate tail edge into the tail edge
clamp with your right hand.
Push the plate tail edge by hand, and check that the plate tail edge (1)
contacts the stopper pins (2). Tum the leading edge clamp open/close
bolt fully in the direction of the arrow.
Operation Edition - 75