Ryobi 3302H Operation Manual page 105

2mmormore
(0.08" or more)
Chapter 1 Operation Procedures
(Note) When reusing a plate with the plate tail edge
waved 2 mm (0.08") or more, the plate tail
edge may not be able to be inserted correctly.
When storing used plates, please put the used
plates on a flat surface so that the plate will
not become wavy.
--~-'
2) Mount a polyester plate or paper master.
(1)
(2)
Bend the plate tail edge fully pushing it down around
the guide (1) using the polyester plate and paper
master bender.
Check that the plate tensioning knobs (1) are
properly loosened.
(Leading edge, Tail edge)
Check that the standard lines (1) of the diagonal
image adjustment are aligned.
The lines can be adjusted by turning the diagonal
image adjustment knob (2).
Operation Edition - 19