Ryobi 3302H Operation Manual page 59

E. ~ Plate load button
When pushing this button, the starting buzzer sounds.
After the buzzer sounds, push the button again. The
press will start to crawl and stop automatically at the
plate mounting position. After that, the buzzer
sounds. Then, insert the plate after opening the safety
cover and push this button. Close the safety cover,
and push this button again. The press will start to
mount the plate automatically. After that, the buzzer
sounds.
(Plate mounting • Operation Edition- 17, 23, and
59)
F. ~ Plate mounted indication lamp
When a plate is mounted on the plate cylinder, this
lamp will light. When the automatic plate tension/
release button functions, this lamp will flicker.
(Reference) When the plate is being mounted
manually, this lamp will not light.
G. ~Plate remove button
When pushing this button, the starting buzzer sounds.
After the buzzer sounds, push the button again. The
press will start to crawl and stop. When pushing the
button again, the press will stop automatically at the
plate tail edge removing position. After that, the
buzzer sounds. Then, open the safety cover, hold the
plate tail edge by hand, and push this button. The
press will crawl in the reverse direction
automatically, and you will be able to remove the
plate. After that, the buzzer sounds.
<When the paper master is mounted without the
tail edge clamped>
When pushing this button, the starting buzzer sounds.
After the buzzer sounds, push the button again. The
press will start to crawl and stop. When pushing the
button again, the press will stop automatically at the
plate leading edge removing position. After that, the
buzzer sounds. Then, open the safety cover, hold the
plate leading edge by hand, and remove the plate. If
the paper master is long, push the forward crawl
button. The press will crawl in the forward direction,
and you will be able to remove the plate.
(Plate removing • Operation Edition - 22, 26, and
61)
Chapter 2 Names and Functions
WARNING
Never touch the rotating parts when doing the
crawl operation. Failure to follow this instruction
may result in a serious injury.
The crawl ON/OFF buttons and crawl buttons are located
at the 2 places marked 1 and 2.
The crawl operation is possible when the crawl ON/OFF
button on each panel is pushed. When pushing the crawl
ON/OFF button, the lamp will light.
a. While lighted ........ The crawl operation can be done.
b. While flickering .... The crawl operation cannot be
done.
(
2 crawl ON/OFF buttons are)
pushed or a safety device is
actuated.
c. While OFF ............ The crawl operation cannot be
done.
Introduction Edition - 21
'-