Ryobi 3302H Operation Manual page 110

Chapter 1 Operation Procedures
A
Operation Edition - 24
Open the safety cover and insert and contact the plate
onto the positioning pins (1) on the leading edge
clamp.
<First unit>
Contact the plate tail edge on the plate tail edge
stoppers (2). Adjust the plate position so that the
"A" part has the same curve on both sides.
(Note) When the paper master is short, the plate
tail edge does not contact to the plate tail
edge stoppers (2). So holding the plate by
the hand, mount the plate.
<Second unit>
Contact the plate tail edge on the plate tail edge
stoppers
(1).
Adjust the side position using the side
plate (2) so that the "A" part has the same curve
on both sides.
(Note) When the paper master is short, the plate
tail edge does not contact to the plate tail
edge stoppers (2). So holding the plate by
the hand, mount the plate.
(Reference) When setting a narrow paper master
which cannot be set on the plate
positioning pins (1), mark with the
center (2) of the paper master on the
leading edge.
Insert the paper master so that the
center (2) of the paper master is aligned
with the center (3) of the leading edge
clamp and contact the paper master
onto the guide pins on the leading edge
clamp.