Ryobi 3302H Operation Manual page 131

Chapter 1 Operation Procedures
[Cycle Indication]
Indication
Cycle type
Setting possible Setting Factory setting
range pitch value
CY-1
Wet cycle for the metal plate
1 to 50 rotations
Every 1
2 rotations
printing mode rotation
CY-2 Inking cycle 1 to 10 rotations
Every 1
2 rotations
rotation
CY-3
Blanket cleaning cycle
20 to 65 rotations
Every 5
20 rotations
rotations
CY-4
Wet cycle for the polyester plate
1 to 50 rotations
Every 1
10 rotations
or paper master printing mode rotation
11~rz~~~~w~~:~-
0 to 50 rotations
Every 1
10 rotations
CY-5
Wet cycle for mounting the paper
rotation
master
[Cycle setting procedures]
CYCLE
SET
(1)
(3)
(2)
IC
~
I
11~1
: = : ,
======~sl
~~~~!'t)
~ ~
There are 2 cycle setting buttons (1) and (2).
When pushing either button, the cycle indication (3)
in the middle changes and at the same time, the cycle
indication and setting value will be indicated on the
counter panel on the delivery section operation
panel.
(Note) When pushing the button (1), the cycle set
number is increased and when pushing the
button (2), the cycle set number is reduced.
The numbers can be changed from 0 to 9.
The setting value is set by using the counter set
button on the delivery section operation panel.
IPresscwithout;Serniautom~tto::,fflat~'~hanQet:l
Set the cycle setting value from the CY-1 to the CY-
4 by repeating the operation above.
(Note) After completing the setting of the set value,
return the cycle set button indication to "0".
l~r~ss:wifh:,S~ml~utomatiQ~BI.~t~~.~haog~~~l
Set the cycle setting value from the CY-1 to the CY-
5 by repeating the operation above.
(Note) After completing the setting of the set value,
return the cycle set button indication to "0".
Operation Edition - 45