Ryobi 3302H Operation Manual page 63

-
J
PRINT
I
COUNTS
A
II
X10
MACHINE
I
COUNTS
B
II Ill
c
D
~
X10
E
DOD
F
0
G
f--0
ODD~
0
CYCLE
SET
00
H
1
!PRINT!
~
5 6
~
2 3 4
~ (4:)
eM
••
7
8
9
Ti
cfJ
A. Print counter
This shows the total number of sheets printed from
the initial operation. This counter counts each sheet
of paper fed through the press whether it is printed
or not.
B. Machine counter
This shows the total number of the cy Iinder rotations.
C. ~ Blanket jam detector button
(With the fail-safe function*)
When this lamp lights, the blanket jam detector stops
the press because a sheet of paper is jammed on any
blanket cylinder on the first unit and second unit.
When wanting to tum OFF this device, push this
button. The lamp will go off.
D. ~ Paper feed jam detector button
(With the fail-safe function*)
When this lamp lights, the paper feed jam detector
stops the press because of sheet travel trouble on the
feeder board.
When wanting to tum OFF this device, push this
button. The lamp will go off.
E. ~ Electronic type double sheet detector
button (With the fail-safe function*)
When this lamp lights, the electronic type double
sheet detector is ON. When wanting to tum OFF this
device, push this button. The lamp will go off.
«NOTICE»
Be sure to use the mechanical type double sheet
detector when printing with the electronic type
double sheet detector switch OFF
If printing is done without the mechanical type
double sheet detector used, the press may be
damaged.
F.
[Q]
Paper master mounting and removing
program switch
This is the ON/OFF switch of the mounting and
removing program for the paper master.
OJ
(ON) ...... The program will operate.
[QJ
(OFF) ..... The program will not operate.
G. ~Paper feed break detector switch
This is the ON/OFF switch of the paper feed break
detector which stops the paper feed when a paper
feed break occurs.
OJ
(ON) ...... The device will operate.
[QJ
(OFF) ..... The device will not operate.
(Note) This switch is not equipped with the fail-safe
function*. Be sure to use the press with this
switch at the
OJ
position.
H. Cycle set button
Use this when setting each process cycle during the
printing or when doing the maintenance and
inspection.
( .,. Operation Edition - 44, Maintenance Edition -
10)
I. ~ Oil warning reset button
When the oil warning lamp lights on the delivery
section operation panel, lubricate the required places
on the press, then push this button. The lamp will go
off.
J. Cycle set indication panel
The cycle number of each process and contents set
by the cycle set button (H) are indicated by the
symbols.
Cycle number
Cycle process
and symbol
0
jPRINTj
Set at this position when printing.
I
~
Wet cycle of the water form roller for
the metal plate printing mode
2
n
Inking cycle
3
0
Blanket cleaning cycle
••
Wet cycle of the water form roller for
4
~
the polyester plate or paper master
printing mode
5 ~
Wet cycle of the water form roller for
the mounting the paper master
8
Tt
Only service technicians use this.
&
Set at this position when doing the
9 roller and cylinder pressure
adjustment.
(Note) There are no functiOns for the cycle numbers 6
and 7.
* : Fail-safe function
When turning ON the press power, the button lamp
of detector will light and each detector will tum ON
automatically so that the press will not be damaged.
Chapter 2 Names and Functions
Introduction Edition - 25