Ryobi 3302H Operation Manual page 143

Chapter 1 Operation Procedures
4) Set the powder spray device.
When setoff is likely to occur during printing, use
(1)
the powder spray device.
When setting the spray switch ( 1) at the
~
position,
powder will be sprayed during printing.
(1)
')
0 " I
(1)
Adjust the position of the spray nozzles (1) to match
the image on the printed sheet.
Control the total spray volume by using the spray
volume control lever (1).
Turn the spray volume control plate (1) by using
the wrench and control the powder spray volume
outputted from each nozzle.
Operation Edition - 57