Replacing The Water Control Wiper - Ryobi 3302H Operation Manual

Chapter 4 Replacing the Supplies
4. Replacing the Water Control Wiper
A
CAUTION
Stop the press before setting. Failure to follow this instruction may result in an injury.
1) Mounting
(1) (2)
Maintenance Edition - 42
When the water control wiper wears out, the printing quality may not be
stable due to the over supply of dampening solution.
Replace it with a new one.
After replacing the sponge blade (1), fix the water control wiper on the
bracket by using the fixing screw (2).
When replacing it, please follow the instructions included with it.
«NOTICE»
Soak the water control wiper in water before mounting
it
on the press.
Mount the wet water control wiper on the press and run the press. By
doing this, stable printing quality is assured immediately after mounting
it.
Mount the water control wiper on the press.