Ryobi 3302H Operation Manual page 89

(2)
Leading edge
=
Chapter 1 Operation Procedures
Set the plate on the punch table. At this time, contact
the back of the plate with the table completely so
that it does not rise off the table. Contact the lateral
positioning pins on the plate edges lightly.
When using a metal plate, the lamp (1) lights when
the plate is set at the correct position.
Loosen the slide bar fixing knob (1) to move the
slide bar by using the slide bar vertical image micro
adjustment knob. Move the slide bar to the position
where the vertical position of the right side register
mark on the plate is aligned with the magnifying
glass register mark.
(Note) For the RP520-220F, the vertical direction
measuring range of the magnifying glass is
from 59 mm (2.32") to 347 mm (13.66").
Therefore, when 2 images are positioned in
the vertical direction on one plate as shown
in the illustration on the left, the register
marks (1) of the tail edge may not be
measured.
When this occurs, please measure the
register marks (2) on the leading edge.
Loosen the magnifying glass block fixing knob (1)
to move the block. Move the block to the position
where the lateral position of the right side register
mark on the plate is aligned with the magnifying
glass register mark.
Tighten the magnifying glass block fixing knob (1),
and turn the magnifying glass lateral image micro
adjustment knob to do the micro adjustment in the
lateral direction.
Operation Edition - 3