Ryobi 3302H Operation Manual page 171

Chapter 1 Maintenance after the Printing
Wipe off all the ink that is adhered on the metering roller using the
exclusive cleaner for the continuous dampening rubber rollers.
«NOTICE»
Release the metering roller by using the metering roller release lever
after completing the daily operation to prevent deformation of the
metering roller shape.
3) Clean the water fountain roller and water oscillating roller.
£WARNING
Stop the crawl operation before cleaning. Failure to follow this
instruction may result in a serious injury.
When completing the daily operation, clean the water fountain roller and
water oscillating roller by using the exclusive cleaner for the continuous
dampening metal rollers.
4) Do the roller maintenance to keep the hydrophilic properties of the roller surface.
£WARNING
Stop the crawl operation before doing the maintenance. Failure
to follow this instruction may result in a serious injury.
When completing the daily operation, do the roller maintenance to keep
the hydrophilic properties of the roller surface by using the exclusive
cleaners for the rubber rollers and metal rollers of the continuous
dampening system.
«NOTICE»
Do not use polishing powder and glaze remover, because the roller
surface will be damaged.
5) Release the water rider oscillating roller from the water form roller.
A
CAUTION
Stop the press before releasing. Failure to follow this instruction may result in an injury.
(1)
Set the water rider oscillating roller release knob ( 1) at the 3 o'clock position
by turning it and pull the water rider oscillating roller by hand toward you
so that it is properly released from the water form roller.
Maintenance Edition - 5