Ethernet Module - Honeywell Galaxy Flex Installer Manual

Galaxy Flex Installer Manual

Ethernet module

The Ethernet module is an optional add-on to the control panel. It is compact and combines
alarm signalling, remote servicing and integrated facilities over Ethernet LAN and/or WAN.
The module connects to 10 Base-T Ethernet networks supporting UDP/IP and TCP/IP
protocols, and has the following features:
Full alarm signalling on SIA
Microtech protocol signalling with Event Monitoring Software
Remote servicing via remote servicing software
Note: The position of components on the Ethernet PCB may vary with different hardware
revisions.
Configuring the module
To configure the module in the system, exit from engineer mode. It is allocated keypad
address 15 (B). If the message XX Mod Added [<],[>] To View is displayed, the system
has recognised the module. Press
message is not displayed or the Ethernet module is not on the list of added modules, then it
is not communicating with the control panel.
The flash rate of the red LED (LED 3) indicates module to panel communication status.
Ethernet communication
The green LED (LED 1) is lit when the module is connected to Ethernet.
The amber LED (LED 2) flashes when the module is sending or receiving data.
For further information refer to Ethernet module, Installation Instructions (II1-0080).
Figure 9 Ethernet module on mounting bracket
or to confirm that comm 4 has been added. If this
A B
Appendix G: Peripherals
223