Honeywell Galaxy Flex Installer Manual page 68

Remote Access [47]
2=Code + Notice
3=No Code/Notice Enables a remote servicing session without the need for a Service PIN
Service Pin [47.4.7]
This is a 6-digit numeric code (default 987654), which initiates an automated call to the
Remote Servicing application. The Service PIN code can only be changed from Remote
Servicing. It is sent to the panel via the Send Remote Access Start Code. The Service PIN
code cannot be the same as any other user codes in the system. This option is only available
when the Schedule [47.4.6.1] option is greater than 0 and when the Code Only [47.4.6.2.1]
option is enabled.
Delay Time [47.4.9]
This is the time that the panel delays for incoming information from the remote servicing
package. The delay time can be set from 3 to 10 seconds. The default is 10 seconds.
SMS Paging [47.5]
Use this option to send all trigger enabled events to a maximum of three different mobile
numbers using the Internal Telecoms module and/or three different numbers using the GSM
module. Options 47.5.1 and 47.5.2 can also be accessed and configured using options
56.1.17.1 and 56.5.17.1 respectively.
The numbers you program are dialled via a single centre number. Failure to communicate
with this number results in a failure to communication with all your programmed numbers.
Dialling is attempted for a maximum time period set in Fail to Comm [56.1.11].
68
Enables the remote servicing notification timer and display of remote
servicing notification. The remote service notification message is not
displayed if the system is set. It only becomes active when the panel is
unset. The message REMOTE CALL INIT, A=SP PIN ENTER is
displayed after entry of a valid manager type user code.
code and the panel's remote servicing notification message. This option
uses the start and end times programmed in option 47.4.2.1 and
47.4.2.2.
Galaxy Flex Installer Manual