Honeywell Galaxy Flex Installer Manual page 123

Galaxy Flex Installer Manual
DTMF [56.1.01.1]
When DTMF (Dual Tone Multiple Frequency) format is selected, the operation of the
Telecom module is similar to that of a hardwired 8 or 16 channel communicator. The
Telecom module transmits as an eight channel communicator if channels 9 to 16 are
programmed as Spare.
Notes:
1. DTMF is fast format.
2. A battery low condition is always sent to the ARC as a code 8 in the status channel.
This may cause problems for some ARCs. If a channel is assigned as Battery Low, then
both the channel and the code 8 in channel 9 are transmitted.
Programming Channels
When you select DTMF, the keypad displays 1=Channels 1 – 16. All 16 channels can be
individually programmed.
To access the Channels option press
displayed.
Select the required channel, or enter the channel number directly.
DTMF Channels 1-16 [56.1.01.1.1]
Each channel can be programmed with the following attributes:
1=Output Function
2=Output Mode
3=Output Polarity
4=Diag Recording (option not available)
5=Descriptor (option not available)
6=Control (option not available)
7=Output Groups
DTMF Channel Output Function [56.1.01.1.1.1]
Any of the system output functions (see Program Outputs [53]) can be assigned to each of
the channels 1 to 16. Channel 3 defaults to output function 04=INTRUDER and Channel 7
defaults to 20=CONFIRM. All other channels default to 11=SPARE.
Select the required output function, and then press
channel. For example, a PA function programmed on channel 2 results in a PA code
transmitted on channel 2 to the ARC, when there is a PA alarm activation.
. The programming details of the first channel are
ent
channel channel output function
CH03 INTRUDER *L
polarity
POS
mode status
A12345678
to assign the function to the selected
ent
Communications [56]
mode
group assigned
123