Honeywell Galaxy Flex Installer Manual page 137

Galaxy Flex Installer Manual
ISDN Primary Format [56.3.01.4]
The ISDN module provides seven signalling formats:
1=DTMF
2=SIA
3=Microtech
4=Contact ID
5=Robofon
6=X.25 Protocol 1 (SIA based format compatible with the OA BX X.25 receiver)
7=X.25 Protocol 2 (SIA based format compatible with the Alphatronics RC 4000 receiver)
Note: The DTMF, SIA, Microtech and Contact ID formats are identical in structure and
programming to the Telecom Module menu.
Note: X.25 Protocol 1 and Protocol 2 are similar in programming structure to the SIA
protocol.
ISDN Secondary [56.3.02]
The secondary option is available to support Dual and Alternate dialling to a second
destination receiver. If using alternate mode both the dial type and format must be identical
to the values programmed for the primary number.
1=Default Telephone Number
2=Default Account Number
3=Dial Type
4=Format
5=Copy Primary (1 to 2)
6=Alternate
ISDN Type [56.3.03]
Two types of ISDN lines are available on the EURO ISDN network; Point to Multipoint and
Point to Point.
The programming is identical to Telephone Number 1
[56.1.02].
Refer to Primary [56.3.01.2].
Refer to Primary Dial Type (except X.25 should be
option not available).
Refer to Primary Format. It is possible to assign different
formats to both the Primary and Secondary numbers,
however, when using the alternative signalling option the
format must be identical.
Copies Primary Program to Secondary Program, for ease
of programming.
If enabled, signalling is attempted alternately to primary
and secondary numbers until successful transmission to
either is achieved. If enabled, the user will be requested
to copy the primary programming to the secondary
programming to ensure both paths are configured
identically.
Communications [56]
137