Access Doors [25] - Honeywell Galaxy Flex Installer Manual

Access Doors [25]

The required option is selected by pressing the appropriate key 1-4. The printing begins
immediately and can be aborted by pressing
Access Doors [25]
Use this option to display the event log information relating to access control events. The
access event log can be filtered using the following options.
View All [25.1]
Use this option to display all events in the access log.
Note: If Access Mode has not been enabled (refer to Access Mode [69.1]) the message No
Entries is displayed on entering this option.
User [25.2]
Use this option to show all events for the selected user. Managers can see all the users.
Individual users can see their own events only.
Reader [25.3]
Use this option to show all events for a particular Access Reader. If there are no MAX/DCM
modules connected to the system the message None Detected is displayed. If there is more
than one device on the system press
Additional function for MAX reader address display
MAX modules, unlike other peripherals, do no have rotary switches to set their addresses.
Pressing in this option displays the address on each module in binary format using LEDs.
#
To help you identify each of the MAX modules, the keypad displays a graphic
representation of each address. By matching the
keyboard to the LEDs on the MAX, you can identify each device on the system.
The line number and address combinations are shown in Figure 8. On a module ignore the
top LED. Read the remaining LEDs from top-to-bottom, transpose to left-to-right, and then
read off the 2-digit decimal address in the table.
44
esc
or to view the details of each device.
A B
Line No. Module address
1
Figure 8 Line number / module address
Galaxy Flex Installer Manual
.
(LED off) and
0
1
2
3
4
5
6
7
(LED on) on the