Ethernet Module - E080; Configuring The Ethernet Module; Ethernet Communication - Honeywell Galaxy 3-48C Installation Manual

Ethernet Module

Ethernet Module - E080

The Ethernet Module is an optional add-on to the Galaxy 3-144 and 3-520 panels. It is a highly intelligent and
compact module, combining alarm signalling, remote servicing and integrated facilities over Ethernet LAN and/
or WAN. The Ethernet Module connects to 10 Base T Ethernet networks both supporting UDP/IP and TCP/
IP protocols.
The Ethernet module supports the following features:
• Full alarm signalling on SIA
• Microtech protocol signalling with Alarm Monitoring Software V3.1/3.2
• Remote servicing via remote servicing software
Programming
Header
NOTE: The position of components on the Ethernet PCB may vary with different hardware revisions

Configuring the Ethernet Module

The added Ethernet Module is configured into the system on exiting from engineer mode and is allocated
keypad address 15 (B). If the message XX Mod Added [<],[>] To View is displayed, the system has
recognised that a new module is present. Press the A or B keys to confirm that com 4 has been added. If
this message is not displayed or the Ethernet Module is not on the list of added modules, then the Ethernet
Module is not communicating with the control panel.
The flash rate of the red LED (LED3) on the Ethernet Module indicates the status of the communication with
the control.

Ethernet Communication

The green LED (LED1) is illuminated when the Ethernet Module is connected to Ethernet.
The amber LED (LED2) flashes when the Ethernet Module is sending or receiving data.
For further information regarding the Ethernet Module, refer to Ethernet Module, Installation Instructions
(II1-0080).
Galaxy 3 Series Installation Manual
Processor
Engineer
Socket
+ -
S A B
Line
Figure 3-10. Ethernet PCB Layout
3-20
Processor
LED1
LED2
SKT2
SKT1
Rev. 1.0