Honeywell Galaxy Flex Installer Manual page 54

Codes [42, Quick Menu 7]
Duress Code
Entry of a Duress Code sends a signal to the monitoring station to indicate a user has been
forced to operate the system under duress. Any user on the system can be designated as a
Duress Code. There is no limit to the number of users that can be assigned as Duress Codes.
To assign a Duress Code:
In the Modify Level option, press
Code.
To assign a User Code as duress:
Enable the Duress User [51.77] option.
Quick Menu
All user codes default to the quick menu. This menu is made up of a selection of ten options
(0 – 9) from the full menu. Access to the quick menu is controlled by the user type. Any
user can be upgraded from the quick menu to the full menu by assigning a
while the Modify Type option is accessed. Therefore a user with type 5 would have access
to the full menu from options 11 – 32. It is not possible to access both menus at the same
time.
To reprogram the options contained in the quick menu refer to Quick Menu [59].
Note: The master manager code defaults to the full menu.
To control the menu options available to each user level refer to Menu Access [68]. You
can allow users to access menu options that their code types are not, by default, authorized
to access.
Modify Name [42.1.User code.3]
Use this option to assign a name to a user with a maximum of 6 alpha-numeric characters.
The default user name is USER. The engineer (ENG) and manager (MGR) are fixed and
cannot be reprogrammed.
To add or modify a user name:
1. Press to erase the characters of the default or previous name.
2. Using or , navigate to the first character of the name, and then press
A B
selected character appears on the top line.
Press to move between upper and lower case characters, and the system library. Enter
#
a character, or word reference number, to access alpha-numeric characters and library
words (see Appendix A: Library).
3. Continue this process until the name is completed.
4. Press to store the name and return to the previous menu level.
esc
54
Galaxy Flex Installer Manual
. The current user code is assigned as a Duress
#
to the user
. The
ent