Subaru SVX 1992 Manual page 515

AUTOMATIC TRANSMISSION AND DIFFERENTIAL
(w4B2) 3- 2
Standard value :
1 .1 - 1 .7 mm (0 .043 - 0 .067 in)
Allowable limit : 2.7 mm (0.106 in)
Before measuring clearance, place the same thickness
of shim on both sides to prevent retaining plate from
tilting.
Available retaining plates
Part No.
Thickness mm (in)
31667AA180 6.5 (0.256)
31667AA190 6.8 (0.268)
31667AA200
7.1 (0 .280)
31667AA210 7 .4 (0 .291)
31667AA220 7 .7 (0 .303)
31667AA230 8 .0 (0 .315)
31667AA240
8 .2 (0 .323)
31667AA250 8 .4 (0 .331)
11) Install the thrust needle bearing to the inner race .
12) Install the forward clutch drum ASSY .
(1) Install carefully while rotating the drum slowly
paying special attention not to damage the seal ring .
(2) Installation is complete when the drum recedes
2.5 mm (0 .098 in) from the inner race surface.
Fig. 195
13) Assemble the overrunning clutch hub .
a. Join the thrust needle bearing and thrust washer
with vaseline, and then install them together .
b. Make sure that the splines are engaged correctly .
rig. I yo
t-1g. 197
15) Assemble the rear internal gear.
(1) Join the thrust needle bearing and thrust washer
to the gear with vaseline, and install the gear while
rotating it .
(2) Securely engage the bearing with the dog of the
overrunning clutch hub .
Installation is complete when the snap ring top surface
of the forward clutch drum recedes approximately 3.5
mm (0.138 in) .
f-1g . 7 98
141
14) Install the one-way clutch outer race ASSY .
Make sure the forward clutch splines are engaged
correctly .