Table of Contents
Advertisement
ENGINE AND TRANSMISSION MOUNTING SYSTEM
[w4AO1 2-11
4. Transmission
A: REMOVAL
1
1 . Set the vehicle on lift arm .
2 . Open front hood fully .
ca
4. Remove air intake system .
5. Remove engine hook .
6 . Remove pitching stopper and bracket.
8 . Disconnect harness connectors.
9 . Remove starter ASSY .
10 . Separate torque converter from drive plate.
11 . Set special tools .
I
12 . Remove bolt which hold upper side of transmission to engine .
13 . Remove ATF level gauge and front differential oil level gauge.
14 . Remove under cover.
15 . Remove exhaust system .
16 . Remove propeller shaft .
i / . nemove selector caDie rrom selector lever HZ~br .
18. Remove selector cable bracket from body .
19 . Remove performance rod .
20 . Remove front axle shaft from transmission .
21 . Disconnect ATF cooler hoses from pipes on transmission side .
22 . Remove nuts which hold lower side of transmission to engine.
23. Place transmission jack under transmission .
24 . Remove transmission rear crossmember .
25 . Remove transmission .
I
19
Advertisement
Table of Contents
Troubleshooting
