Table of Contents
Advertisement
FUEL SYSTEM
[W7BO1 2-8
~
B: INSPECTION
1) Connect the leads to the harness connector, and
apply a 12-volt power supply to check whether the
pump operates .
a. Keep the battery apart from the pump as far as
possible.
b. Be sure to turn the 12V supply ON and OFF on the
battery side.
c. Do not run the pump for a long time under non-
loaded condition .
C: INSTALLATION
Installation is in the reverse order of removal proce-
dures. Observe the following .
(1) Always use a new gasket .
(2) Ensure sealing portion is free from fuel or foreign
particles before installation . (Wipe mounting holes,
packing, etc . with a cloth .)
(3) When installing fuel tank cap, use special tool .
Special tool :
REPLACER (42911 PA000)
7 . Fuel Meter Unit
A: REMOVAL
Fuel meter unit is built into fuel pump ASSY, so that
removal of fuel meter unit is in the same order for fuel
pump .
1) Release fuel pressure .
Refer to section 1 . [W1A0].
2) Disconnect fuel delivery hose, return hose, evapora-
tion hose and air vent hose .
3) Remove fuel tank cap using special tool .
4) Take out fuel meter unit .
Refer to Fig. 31 .
(4) Connect fuel delivery hose, return hose and
fig . .37
evaporation hose .
(5) Connect fuel pump connector.
B: INSTALLATION
Refer to "INSTALLATION" of fuel pump .
17
Advertisement
Table of Contents
Troubleshooting
