Inflation Pressure; N : Wheel Nuts For Looseness And Tire; O : Seat Adjuster And Seat Belts - Subaru SVX 1992 Manual

PRE-DELIVERY INSPECTION [oloo] 1-4
N: WHEEL NUTS FOR LOOSENESS AND
TIRE INFLATION PRESSURE
CHECK POINTS
1 . Wheel nut tightening torque
2. Tire inflation pressure and tire specification
3. Damage to tire and rim
Tightening torque :
98 - 118 N"m (10.0 - 12.0 kg-m, 72 - 87 ft-Ib)
Tire pressure:
Front: 226 kPa (2.3 kg/cm', 33 psi)
Rear : 196 We (2.0 kg/cm', 28 psi)
T type tire : 412 kPa (4 .2 kg/cm', 60 psi)
When top strap anchor is used for rear seat :
1) Take out the anchor set from inside the glove box
and check that its components are assembled as shown
in Fig .
1
Cover
2 Bolt ASSY (5/16 in)
3 Anchor plate
4 Spacer
5 Setting washer
0
raN
C1-098
a. When checking the wheel nuts, be sure to use a
torque wrench, and tighten the nuts to the specified
torque .
b. After inspecting and adjusting the tire pressure, be
sure to put the valve cap back.
O : SEAT ADJUSTER AND SEAT BELTS
CHECK POINTS
1. Front and rear seats, and their facing materials
2. Front seat operation
3. Rear seat folding operation
4. Seat belts and their fit
3. Installing procedure for child anchor
Automatic belt type
a. After inserting shoulder belt into emergency release
buckle, open and close the door to check that shoulder
anchor moves smoothly without binding.
b. Check that tongue unlatches when emergency re-
lease button is pushed. Also check that tongue clicks
and latches when inserted into place.
c. The seat belt warning light on the instrument panel
comes on for approximately six seconds when the
ignition switch is turned "ON" .
d. And the warning chime sounds if the driver's lap
belt is not fastened or Automatic shoulder belt-
emergency release buckle is released .
e. Make sure that the warning system works normally.
Installing procedure for child anchor
Fig. . 13
2) The anchor installation points are covered with caps .
Remove the cap at the desired anchor installation
points .
C1-024
Fig . 14
Fig. 15
7