Engine Speed Sensing Type - Subaru SVX 1992 Manual

4-3 [W4B1]
STEERING SYSTEM
ASSY mounted to the vehicle, and remove oil from the
surrounding portions . Then, turn the steering wheel
from lock to lock 30 to 40 times with the engine running,
then make comparison of the leaked portion immedi-
ately after and several hours after this operation .
(1) Leakage from "e"
The cylinder seal is damaged . Replace rack bush
ASSY with a new one .
(2) Leakage from "f"
There are two possible causes . Take following step
first. Remove the pipe ASSY B from the valve hous-
ing, and close the circuit with PLUG (926420000).
Turn the steering wheel from lock to lock 30 to 40
times with the engine running, then make compari-
son of the leaked portion between immediately after
and several hours after this operation .
a. If leakage from "Y' is noted again :
The oil seal of pinion fr valve ASSY is damaged.
Replace pinion fr valve ASSY with a new one. Or
replace the oil seal and the parts that are damaged
during disassembly with new ones.
b. If oil stops leaking from "f" :
The oil seal of rack housing is damaged.
Replace the oil seal and the parts that are damaged
during disassembly with new ones .
B: DISASSEMBLY
1 . ENGINE SPEED SENSING TYPE
1) Remove dust cover .
a . Be careful not to scratch housing or input shaft
during dust cover removal. Also do not allow foreign
matter to enter housing interior .
b. Replace dust cover with a new one if its inside bore
or lips are worn or damaged .
b. Check rotor for bends and serrations for damage;
replace as required.
a
Fig. 109
(2) Using REMOVER and press, remove dust seal,
back-up washer, Y-packing and ball bearing from
valve housing .
a . Use the "A" end of remover .
b. Do not apply a force to end surface of valve hous-
ing.
c. Do not reuse Y-packing after removal.
B side
REMOVER
(927540000)
Dust seal
Back-up waher
Y-packing
Ball bearing
A side
04-062
Fig. 108
Fig . 110
(3) Remove snap ring securing valve sleeve to pinion
£r valve ASSY, and remove valve sleeve .
Before removal, paint alignment mark on the original
position between valve sleeve groove and pinion pin .
2) Removal of valve ASSY
Refer to Step 11) to 15) on [W3C0].
1) Disassembly and reassembly of valve ASSY
(1) Press pinion £r valve ASSY out from valve hous-
ing .
a . Discard Y-packing after removal ; replace with a
new one .
50