Table of Contents
Advertisement
STEERING SYSTEM
[W3Eo] 4-3
rig . 9s
c. Ensure that boot is free from abnormal swelling or
dents .
(3) Wind two complete turns of lock wire on large
end of boot, and twist it while pulling it upward (with
a force of approximately 29 N- 49 N (3 N- 5 kg, 7 N-
11 lb) . Then bend wire end along boot as shown .
a . Wind up wire until it contacts boot.
b. Ensure that lock wire is not loose.
hg . 7 Uo
(4) Install clip using pliers.
After installing clip, ensure that boot's small end is
properly positioned in groove on tie-rod CP .
rig. I u l
(5) If tie-rod end was removed, screw in lock nut and
tie-rod end to screwed portion of tie-rod, and tighten
lock nut temporarily in a position as shown in the
illustration .
Fig. 102
Pay attention to difference between right and left
tie-rod ends.
I
Identification mark
Left one
LH
Right one
RH
7) Inspect gear box ASSY as follows :
Fig . 103
(1) Holding tie-rod end, repeat lock to lock two (2) or
three (3) times as quickly as possible .
(2) Holding tie-rod end, turn ASSY slowly at a radius
one (1) or two (2) times as large as possible .
After all, make sure that boot is installed in the
specified position without deflation .
8) Install four pipes on gearbox .
Tightening torque :
29 - 39 N"m (3 .0 - 4.0 kg-m, 22 - 29 ft-Ib)
47
Advertisement
Table of Contents
Troubleshooting
