Rear Cushion Rubber - Subaru SVX 1992 Manual

ENGINE AND TRANSMISSION MOUNTING SYSTEM Iw5e01 2-11
5. Rear Cushion Rubber
A: REMOVAL
1) Set the vehicle on lift arm .
Refer to C.1-3 .
2) Open front hood .
3) Remove exhaust system .
(1) Disconnect OZ sensor 1 Fr 2 (RH £r LH) connector.
(2) Lift up the vehicle.
(3) Remove under cover.
(4) Remove Oz sensor harness from clip .
(5) Remove front exhaust pipe and rear catalyst
converter.
Refer to C.2-9.
4) Place transmission jack under transmission .
5) Remove transmission rear crossmember.
rig. 0/
F B-, INSTALLATION
Installation is in the reverse order of removal proce-
dures.
1) Install rear cushion rubber .
Tightening torque : N-m (kg-m, ft-Ib)
18-31 (1 .8-3.2, 13-23)
2) Install transmission rear crossmember .
\\
T1
T2
T3
T1
~~D~L~ ~ ®000[® ® .
// T1
- ~T3
T1
C2-9oo
Fig . 69
Tightening torque : Nom (kg-m, ft-Ib)
T1 : 54-83 (5 .5-8.5, 40-61)
T2 : 23 - 36 (2.3 - 3.7, 17 - 27)
T3 : 27 - 47 (2 .8 - 4.8, 20 - 35)
6) Remove rear cushion rubber .
Rear cushion
rubber
_ ®(°)
(0 1~ I
C2-123
Fig. 68
3) Take off transmission jack .
4) Install exhaust system .
(1) Install rear catalyst converter and front exhaust
pipes.
(2) Install OZ sensor harness to clip .
(3) Install under cover.
(4) Lower the vehicle .
(5) Connect OZ sensor 1 £t 2 connector.
Refer to C.2-9.
5) Close front hood .
6) Remove vehicle from lift arm .
Refer to C.1-3 .
29