Subaru SVX 1992 Manual page 699

WHEELS AND AXLES [WlDo] 4-2
c. Do not replace inner or outer race separately ; al-
ways replace as a unit.
BEARING INSTALLER "FRONT"
(28099 PA000)
OUSING STAND
FRONT"
8099 PA010) (~~A
C4-329
Fig . 27
8) Loosen bolts which secure tone wheel to hub. Re-
move tone wheel .
HUB STAND
(28099 PA080)
Tone wheel
C4-350
Fig. 28
9) Using HUB STAND (28099PA080) and a hydraulic
press, drive hub bolts out .
Be careful not to hammer hub bolts. This may deform
hub.
C4-348
Fig . 29
C: INSPECTION
Check the removed parts for wear and damage . If
defective, replace with a new one.
a. If a bearing is faulty, replace it as the bearing set.
b. Be sure to replace oil seal at every overhaul.
JJ~IJJJJ}
Replace as a set .
B4-596
Fig . 30
D: ASSEMBLY
1) Attach hub COMPL to HUB STAND (28099PA080)
securely.
2) Using a hydraulic press, press new hub bolts into
place.
a. Use 12 mm (0.47 in) dia. holes in HUB STAND to
prevent bolts from tilting.
b. Be sure to press hub bolts until their seating sur-
faces contact the hub.
HUB STAND
(28099 PA080)
C4-349
Fig . 31
3) Remove foreign particles (dust, rust, etc .) from mat-
ing surfaces of hub and tone wheel, and install tone
wheel to hub .
a. Ensure tone wheel closely contacts hub.
b. Be careful not to damage tone wheel teeth:
15