Table of Contents
Advertisement
2-4 [W1E0]
ENGINE LUBRICATION SYSTEM
~
E : INSTALLATION
-/
T 6 - 7 (0 .6 - 0 .7, 4.3 - 5.1)
n
[
~-
I
\`
S,.
T ni .m (kg-m, ft-Ib)
C2-148
Fig. 15
Installation is in the reverse order of removal .
Observe the following :
1) Apply fluid packing to matching surfaces of oil
pump .
Fluid packing:
Three bond 1215B or equivalent
0
0
Fluid packing
tt O
o
o
\
Da
C
® C 2 - 3 2 1
Fig. 16
2) Replace O-ring with a new one .
3) Be careful not to scratch oil seal when installing oil
pump on cylinder block.
4) Apply fluid packing to thread portions of oil pump
mounting bolts (3 places) shown in figure below .
Fluid packing :
Three bond 1344 or equivalent
o L=~
0
C2-322
Fig . 17
Apply fluid packing to oil pressure switch threads
before installation .
Fluid packing:
Three bond 1324 or equivalent
2 . Oil Pan
A: REMOVAL
1) Open the front hood .
2) Disconnect ground cable from the negative terminal
of battery.
3) Disconnect left hand 02 sensor connector .
4) Remove bolts which connect oil level gauge to
cylinder head .
5) Drain engine oil .
6) Lift up the body .
7) Remove under cover .
8) Remove left-hand exhaust manifold cover, front ex-
haust pipe and exhaust manifold .
(Refer to "2-9 Exhaust Manifolds [W2A]" .)
9) Remove steering gear box clamps .
(Do not disconnect tie rod end from knuckle arm .)
10) Disconnect oil level gauge guide from oil pan .
11) Remove the bolts securing the oil pan to the cylin-
der block. To facilitate removal of the two rear oil pan
mounting bolts, use a socket wrench with a universal
joint.
12
Advertisement
Table of Contents
Troubleshooting
