Subaru SVX 1992 Manual page 873

BRAKES [w3C0) 4-4
C4-558
Fig . 80
7) Fasten caliper assembly to strut with wire
Fig. 81
8) Remove disc rotor.
If disc rotor seizes up within hub, drive it out by install-
ing 8-mm bolts into holes "B" in disc rotor.
C4-540
Fig . 82
9) Remove shoe return spring from parking brake
ASSY.
10) Disconnect hold-down cup from hold-down pin by
rotating hold-down cup .
11) Remove strut and strut spring .
12) Remove adjuster ASSY and adjuster spring .
13) Disconnect lever from parking brake cable.
0
C4-557
Fig . 83
B : INSPECTION
1) Measure brake disc inside diameter . If the disc is
scored or worn, replace the brake disc .
Disc inside diameter :
Standard
190 mm (7 .48 in)
Service limit
191 mm (7 .52 in)
2) Measure the lining thickness . If it exceeds the limit,
replace shoe ASSY .
Lining thickness:
Standard
3.2 mm (0.126 in)
Service limit
1.5 mm (0.059 in)
Replace the brake shoes on the right and left brake
ASSY at the same time.
Use new retainers and clinch them when installing
brake shoes to levers .
C : INSTALLATION
Be sure lining surface is free from oil contamination .
Brake grease :
Dow Corning Molykote No 7439 (P/N 725191460)
1) Apply brake grease to the following places . (Refer to
Figure 77.)
(1) Six contact surfaces of shoe rim and back plate
packing .
(2) Contact surface of shoe wave and anchor pin
(3) Contact surface of lever and strut
(4) Contact surface of shoe wave and adjuster as-
sembly
(5) Contact surface of shoe wave and strut
(6) Contact surface of lever and shoe wave
43