Clear Memory Mode - Subaru SVX 1992 Manual

2-7 [T5EOI FUEL INJECTION SYSTEM
E : CLEAR MEMORY MODE
Start engine.
Warm up engine .
Turn ignition switch OFF .
Connect test mode terminal .
Connect read memory terminal .
Turn ignition switch ON (engine off) .
CHECK ENGINE light turns ON .
I
~
Depress accelerator pedal completely and then return it
to half-throttle position and hold it there for two sec-
onds . Release accelerator pedal completely .
Start engine .
CHECK ENGINE light blinks to indicate vehicle specifica-
tion code.
O
YES
Drive at speed greater than 11 km/h (7 mph) for at least
one minutes .
Warm up engine above 2,000 rpm .
I Check if CHECK ENGINE light blinks .
YES
NO
I Check if CHECK ENGINE light indicates trouble code .
YES
Turn ignition switch OFF.
Disconnect test mode terminal and read memory termi-
nal .
Confirm trouble code .
Make sequential checks of trouble codes .
END
I I After sequential checks, go to D-check mode again .
38