Subaru SVX 1992 Manual page 372

FUEL SYSTEM JW3B01 2-8
13) While holding fuel tank, remove bolts from bands
and dismount fuel tank.
rig. / /
Two man are required to perform step 13) above.
B: INSTALLATION
Installation is in the reverse order of removal proce-
dures.
Observe the following :
1) When installing fuel tank, have a helper hold fuel tank
while installing bands .
Be careful not to damage fuel tank.
2) Before tightening band mounting bolts, connect fuel
system hoses .
3) Install hose and tube holddown clips at positions
indicated in the figure.
Hose Clip
Pipe
L12
L
Fuel return line :
L - 20 - 25 mm (0.79 - 0.98 in)
Evaporation line :
L = 15 - 20 mm (0.59 - 0 .79 in)
B2-259
Fig. 18
Fitting
-Clamp
Hose
-~- 1 - 4 (0 .04 - 0 .16)
When fitting length
is specified
20 - 25 (0.79 - 0 .98)
1 - 4 (0.04 - 0 .16) ~I--If-
Unit : mm (in)
When fitting length is not specified
B2-260
Fig. 19
Tightening torque :
1 .0 - 1 .5 N"m (0 .1 - 0.15 kg-m, 0.7 - 1 .1 ft-Ib)
4) Tighten band mounting bolts.
Tightening torque :
23 - 42 Nom (2 .3 - 4.3 kg-m, 17 - 31 ft-Ib)
J
1
Band
C2-036
Fig. 20
5) Install rear sub-frame .
Refer to C.4-3 .
6) Install rear differential ASSY and propeller shaft.
Refer to C.3-4 .
7) Connect rear axle shaft for rear differential ASSY .
Refer to C.4-2 .
8) Install muffler and rear exhaust pipe .
Refer to C.2-9 .
9) Lower the vehicle .
10) Connect fuel tank connector .
13