W Service Procedure; Oil Pump - Subaru SVX 1992 Manual

ENGINE LUBRICATION SYSTEM [W1A0] 2-4
W SERVICE PROCEDURE
1 . Oil Pump
~A: REMOVAL
1) Open the front hood .
2) Disconnect ground cable from the negative terminal
of battery.
3) Drain engine oil.
4) Remove under cover.
5) Remove bolts which connect power steering oil
cooler pipe ASSY to body .
(Do not remove power steering oil cooler pipe ASSY .)
6) Remove radiator fan motor ASSYs.
7) Remove drive belt cover and drive belts.
(Refer to 1-5 "Drive Belts [01A0]".)
8) Remove A/C belt idler pulley ASSY.
9) Remove power steering pump bracket.
(Do not remove power steering pump .)
10) Remove crank angle sensors .
11) Remove crank shaft pulley .
12) Remove timing belt covers, timing belt and related
parts.
(Refer to 2-3 "Timing Belt [W2A0]" .)
13) Remove crank shaft sprocket, belt idlers, belt ten-
sioner and belt tensioner bracket.
(Refer to 2-3 "Timing Belt [W2A4]".)
14) Remove oil pump
Insert flat bladed screwdriver as shown in Figure .
Be careful not to scratch mating surfaces of cylinder
block and oil pump .
C2-145
Fig. 8
9