Subaru SVX 1992 Manual page 714

4-2 [W4A0]
WHEELS AND AXLES
19) Remove disc rotor.
If disc rotor seizes up within hub, drive it out by install-
ing an 8-mm (0 .31 in) bolt hole in disc rotor.
20) Remove parking brake lining and disconnect cable
from lining .
Fig . 84
21) Remove parking brake cable clamp ; remove cable
from back plate.
Fig . 85
22) Remove BJ from housing. If it is hard to remove,
use REMOVER (926470000) and PLATE (28099PA110) .
a. Be careful not to damage oil seal lip when removing
BJ .
b . When replacing BJ, also replace inner oil seal with a
new one.
23) Remove securing bolts and housing .
24) Install in reverse order of removal .
For installation and tightening torque of suspension
parts, refer to 4-1 [C200] .
For installation and tightening torque of brake parts,
refer to 4-4 [C200] .
a. Be careful not to damage inner oil seal lip.
b. Use a new self-locking nut.
c. Use a new axle nut.
d. Always tighten axle nut before installing wheel on
vehicle. If wheel is installed and comes in contact with
ground when axle nut is loose, wheel bearings may be
damaged.
e. Be sure to tighten axle nut to specified torque . Do
not overtighten it as this may damage wheel bearing.
f. When front drive shaft is to be replaced, also replace
inner oil seal with a new one.
25) After tightening axle nut, lock it securely .
30